Výsledky vyhledávání
- Effect of hydraulic oil entering the cutting fluid on the tool life and roughness in milling of structural steel / Alexey Popov, Mikhail Khramenkov . Manufacturing Technology.Vol. 19, no. 3, strana 482-486.
- Effect of hydraulic oil entering the cutting fluid on the tool life and roughness in turning of stainless steel / Alexey Popov, Mikhail Khramenkov . Manufacturing Technology.Vol. 19, no. 4, strana 664-667.
- The change of tool life in a wide range of cutting speeds in hard turning / János Kundrák, Zoltán Pálmai . Manufacturing Technology.Vol. 19, no. 2, strana 254-260.
- The impact of changes in infeed rate on surface integrity after chrome plate grinding by microcrystalline corundum / Martin Marek, Martin Novák, Karel Šramhauser . Manufacturing Technology.Vol. 19, no. 3, strana 461-468.
- Investigation on the effects of exchanged power and electrode properties on micro EDM drilling of stainless steel / Gianluca D’Urso, Chiara Ravasio . Manufacturing Technology.Vol. 19, no. 2, strana 337-344.
- Qualitative evaluation of machined surface of aluminum alloy AlCu4Mg1 depend on feed rate / Frantisek Botko, Michal Hatala, Zuzana Mitalova, Robert Cep, Miroslav Rimar, Andrej Bernat, Jaroslav Vybostek . Manufacturing Technology.Vol. 18, no. 2, strana 201-207.
- Some aspects of plastic strain in chip creation / Karol Vasilko . Manufacturing Technology.Vol. 18, no. 1, strana 140-144.
- Tribological mechanism in chip formation and its use to improve machining process / Karol Vasilko . Manufacturing Technology.Vol. 19, no. 6, strana 1060-1066.