Výsledky vyhledávání

  1. Analysis of the effect of feed on chip size ratio and cutting forces in face milling for various cutting speeds / János Kundrák, Angelos P. Markopoulos, Tamás Makkai, István Deszpoth, Antal Nagy   .  Manufacturing Technology.Vol. 18, no. 3, strana 431-438.
    Analysis of the effect of feed on chip size ratio and cutting forces in face milling for various cutting speeds
  2. Analysis of the effect of trochoidal milling on the surface roughness of aluminium alloys after milling / Jerzy Józwik   .  Manufacturing Technology.Vol. 19, no. 5, strana 772-779.
    Analysis of the effect of trochoidal milling on the surface roughness of aluminium alloys after milling
  3. Bezpečnost při svařování plamenem a řezání kyslíkem / Připr. Augustin Plešinger a kol   .  Praha :  Práce,  1969 . 268, [2] s.
    Umístění Volné Nedostupné/Prezenčně Vypůjčené Rezervace
    sklad E10/000
  4. Dependence of surface roughness on depth of cut for aluminum alloy AlCu4Mg1 / Dusan Mital, Michal Hatala, Andrej Bernat, Andrej Czan, Jartoslav Vybostek, Nicolae Ungreanu   .  Manufacturing Technology.Vol. 18, no. 2, strana 285-288.
    Dependence of surface roughness on depth of cut for aluminum alloy AlCu4Mg1
  5. Design of triaxial production device / Jakub Kaščak, Monika Telišková, Jozef Török, Marek Kočiško, Martin Pollák   .  Manufacturing Technology.Vol. 18, no. 3, strana 406-410.
    Design of triaxial production device
  6. Effect of waterjet machining parameters on cut quality of polymeric composite materials based on biological reinforcement in form of cotton post-harvest line residues / Miroslav Müller, Viktor Kolář, Petr Valášek   .  Manufacturing Technology.Vol. 19, no. 4, strana 647-654.
    Effect of waterjet machining parameters on cut quality of polymeric composite materials based on biological reinforcement in form of cotton post-harvest line residues
  7. The change of tool life in a wide range of cutting speeds in hard turning / János Kundrák, Zoltán Pálmai   .  Manufacturing Technology.Vol. 19, no. 2, strana 254-260.
    The change of tool life in a wide range of cutting speeds in hard turning
  8. Impact of cutting speed on grinding wheel wear and cutting force when grinding cermet / Tomas Baksa, Jindrich Farsky, Ondrej Hronek, Miroslav Zetek   .  Manufacturing Technology.Vol. 18, no. 5, strana 699-703.
    Impact of cutting speed on grinding wheel wear and cutting force when grinding cermet
  9. Impact of technological parameters of CO2 laser cutting on oxide adhesion forces on the base material / Andrej Zrak, Szymon Tofil, Jozef Šutka, Ján Moravec   .  Manufacturing Technology.Vol. 19, no. 6, strana 1094-1099.
    Impact of technological parameters of CO2 laser cutting on oxide adhesion forces on the base material
  10. The implementations of suitable cutting parameters by grinding of titanium VT9 with impact on surface integrity / Dana Stancekova, Anna Rudawska, Miroslav Neslušan, Jozef Mrázik, Miroslav Janota   .  Manufacturing Technology.Vol. 19, no. 5, strana 855-859.
    The implementations of suitable cutting parameters by grinding of titanium VT9 with impact on surface integrity