Výsledky vyhledávání

  1. Analysis of the impact of the change of primary and secondary AlSi9Cu3 alloy ratio in the batch on its performance / Dana Bolibruchová, Marek Matejka, Michal Kuriš   .  Manufacturing Technology.Vol. 19, no. 5, strana 734-739.
    Analysis of the impact of the change of primary and secondary AlSi9Cu3 alloy ratio in the batch on its performance
  2. The application of DLC coating on convex-concave (C-C) gearings / Ernest Gondár, Miroslav Bošanský, Juraj Rusnák, František Tóth , Jana Repková   .  Manufacturing Technology.Vol. 19, no. 6, strana 930-935.
    The application of DLC coating on convex-concave (C-C) gearings
  3. Cores produced by geopolymer technology and impact to casting quality in comparison with PUR cold box amin / Michal Vykoukal, Alois Burian, Markéta Přerovská, Milan Luňák, Štefan Kyselka   .  Manufacturing Technology.Vol. 19, no. 6, strana 1071-1079.
    Cores produced by geopolymer technology and impact to casting quality in comparison with PUR cold box amin
  4. The crack analysis of fatigue tested steel construction / Zbynek Bunda, Ludmila Kucerova, Miloslav Kepka   .  Manufacturing Technology.Vol. 19, no. 4, strana 559-562.
    The crack analysis of fatigue tested steel construction
  5. Determination the influence of load-rate on strain and spring-back magnitude for titanium alloy by means of numerical simulation / David Koreček, Pavel Solfronk, Jiří Sobotka, Michaela Kolnerová   .  Manufacturing Technology.Vol. 19, no. 1, strana 82-88.
    Determination the influence of load-rate on strain and spring-back magnitude for titanium alloy by means of numerical simulation
  6. Dynamic mechanical analysis of rubber mixtures filled by carbon nanotubes / Dana Bakošová   .  Manufacturing Technology.Vol. 18, no. 3, strana 345-351.
    Dynamic mechanical analysis of rubber mixtures filled by carbon nanotubes
  7. Effect of cryogenic treatment on properties of cemented carbides / Vojtěch Průcha, David Bricín, Antonín Kříž   .  Manufacturing Technology.Vol. 19, no. 1, strana 129-134.
    Effect of cryogenic treatment on properties of cemented carbides
  8. Effect of powder recycling in laser-based powder bed fusion of Ti-6Al-4V / Lucia Denti, Antonella Sola, Silvio Defanti, Corrado Sciancalepore, Federica Bondioli   .  Manufacturing Technology.Vol. 19, no. 2, strana 190-196.
    Effect of powder recycling in laser-based powder bed fusion of Ti-6Al-4V
  9. Effect of Zr on selected properties and porosity of AlSi9Cu1Mg alloy for the purpose of production of high-precision castings / Dana Bolibruchová, Michal Kuriš, Marek Matejka   .  Manufacturing Technology.Vol. 19, no. 4, strana 552-558.
    Effect of Zr on selected properties and porosity of AlSi9Cu1Mg alloy for the purpose of production of high-precision castings
  10. The change of tool life in a wide range of cutting speeds in hard turning / János Kundrák, Zoltán Pálmai   .  Manufacturing Technology.Vol. 19, no. 2, strana 254-260.
    The change of tool life in a wide range of cutting speeds in hard turning